R&S SGT100A User Manual page 256

®
R&S SGT100A
The dialog contains all parameters for configuring the sensor settings, like average
or peak display, reference source, filter and level offset. It automatically displays a
separate tab per detected sensor, see
The remote commands required to define these settings are described in
ter 11.13, "SENSe, READ, INITiate and SLISt
the triggering of the measurement and the retrieval of measurement results.
Serial Number
Indicates the type and the serial number of a connected R&S NRP power sensor.
The displayed
sor.
Remote command:
:SENSe<ch>[:POWer]:TYPE?
:SENSe<ch>[:POWer]:SNUMber?
Level (Peak) / Level (Average)
Indicates the measured peak or average level value.
You can also change the unit for the results display: Watt, dBm or dBμV.
Note: Peak level measurements are provided if the power sensor supports this feature.
User Manual 1176.8674.02 ─ 07
Level (Peak) / Level (Average)
on page 338
Signal Generator Settings
NRP Power Viewer
Subsystems",
values correspond to the particular sen-
on page 336
RF Settings
Settings.
Chap-
on page 329, including
225