Source:power Subsystem - R&S SGT100A User Manual

®
R&S SGT100A
[:SOURce<hw>]:PULM:TRIGger:EXTernal:SLOPe <Slope>
Parameters:
<Slope>
Example:
Manual operation:
[:SOURce<hw>]:PULM:TRIGger:MODE <Mode>
Selects the trigger mode for pulse modulation.
Parameters:
<Mode>
Example:
Manual operation:
[:SOURce<hw>]:PULM:WIDTh <Width>
Sets the width of the generated pulse. The width determines the pulse length. The
pulse width must be at least 20ns less than the set pulse period.
Example:
Manual operation:

11.14.17 SOURce:POWer Subsystem

[:SOURce]:POWer:ALC:DSENsitivity
[:SOURce]:POWer:ALC:SONCe
[:SOURce]:POWer:ALC[:STATe]
[:SOURce]:POWer:ATTenuation:DIGital
[:SOURce]:POWer:ATTenuation:RFOFf:MODE
User Manual 1176.8674.02 ─ 07
NEGative | POSitive
*RST: POSitive
PULM:TRIG:EXT:SLOP NEG
The pulse generator is triggered on the negative slope of the
external trigger signal.
See "Ext. Trigger Input Slope"
AUTO | EXTernal | EGATe
AUTO
The pulse modulation is generated continuously.
EXTernal
The pulse modulation is triggered by an external trigger event.
The trigger signal is supplied via the trigger connector.
EGATe
The pulse modulation is gated by an external gate signal. The
trigger signal is supplied via the trigger connector.
*RST: AUTO
PULM:TRIG:MODE EXT
selects triggering by an external trigger event.
See "Trigger Mode" on page 233
PULM:WIDT 33 us
sets a width of 33 us for the pulse.
See "Pulse Width" on page 232
............................................................................... 466
...................................................................................... 466
..................................................................................... 466
........................................................................... 466
.................................................................467
Remote Control Commands
SOURce Subsystem
on page 233
465