Source:phase Subsystem; Source:pulm Subsystem - R&S SGT100A User Manual

®
R&S SGT100A
<DeltaPower>
Example:
Usage:

11.14.15 SOURce:PHASe Subsystem

[:SOURce]:PHASe
[:SOURce]:PHASe:REFerence
[:SOURce]:PHASe <Phase>
Specifies the phase variation relative to the current phase.
Parameters:
<Phase>
Manual operation:
[:SOURce]:PHASe:REFerence
Adopts the phase set with command
Usage:
Manual operation:

11.14.16 SOURce:PULM Subsystem

This subsystem contains the commands for setting the pulse modulation.
Programming Examples
Example: Performing pulse modulation
This example shows a command sequence to perform pulse modulation.
// ******************************************************************
// Reset the instrument to start from an initial state
// ******************************************************************
*RST; *CLS
User Manual 1176.8674.02 ─ 07
float
Range: -20 to 20
Increment: 0.01
*RST: 0
See Example "Defining correction coefficients and enabling digi-
tal predistortion" on page 447
Query only
......................................................................................................... 460
........................................................................................ 460
float
Range: -360 to 360
Increment: 0.1
*RST: 0
Default unit: DEG
See "Delta Phase"
[:SOURce]:PHASe
Event
See "Reset Delta Phase Display"
Remote Control Commands
on page 200
as the current phase.
on page 200
SOURce Subsystem
460