Sine Test Signal - R&S SGT100A User Manual

®
R&S SGT100A
7.1.2.5

Sine Test Signal

This dialog provides settings for configuration of a sinusoidal test signal. A sine wave is
generated on the I path, and a sine wave of the same frequency but phase-shifted is
generated on the Q path.
The dialog displays the characteristic of the currently selected signal.
Frequency
Enters the frequency of the test signal.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:FREQuency
Samples per Period
Enters the number of sample values required from the sine wave per period.
The maximum allowed value is determined by the maximum ARB clock rate (see data
sheet) and the selected frequency.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:SAMPles
Phase Offset Q
Enters the phase offset of the sinewave signal on the Q channel relative to the sinew-
ave signal on the I channel.
User Manual 1176.8674.02 ─ 07
Signal Generator Settings
Baseband
on page 368
on page 368
106