R&S SGT100A User Manual page 264

®
R&S SGT100A
"Not Signal Valid"
"Pulse Video Out"
"Pulse Gen Ext Trigger"
"Pulse Mod Ext Source"
Remote command:
:CONNector:USER<ch>:OMODe
Trigger Mode
Selects between continuous pulse modulation or pulse modulation triggered by an
external signal.
"Auto"
"Ext Single"
"Ext Gated"
Remote command:
[:SOURce<hw>]:PULM:TRIGger:MODE
Ext. Trigger Input Slope
Available only for "Trigger Mode > Ext Triggered "
Sets the polarity of the active slope of an applied external trigger signal.
Remote command:
[:SOURce<hw>]:PULM:TRIGger:EXTernal:SLOPe
Gate Input Polarity
Available only for "Trigger Mode > Ext Gated "
Sets the polarity of the active slope of an applied gate signal.
Remote command:
[:SOURce<hw>]:PULM:TRIGger:EXTernal:GATE:POLarity
User Manual 1176.8674.02 ─ 07
Output of high signal to mark the transition state when frequency and
level change.
Available only for USER 2.
Output of the internally generated pulse video (modulating) signal.
The video signal level corresponds to the RF envelope.
Available only for USER 2.
Input for an external trigger signal, used to trigger the pulse genera-
tor.
Available only for USER 2.
Input for an externally provided pulse modulation signal.
Used when an external pulse modulator source is provided at the
connector.
on page 315
Generates the modulation signal continuously.
Generates the signal each time an external trigger event occurs.
Generates the signal triggered by an external gate signal.
Signal Generator Settings
on page 465
on page 465
RF Settings
on page 464
233