Source:correction Subsystem - R&S SGT100A User Manual

®
R&S SGT100A
[:SOURce<hw>]:BB:POWer:PEAK?
This command queries the peak power of the baseband signal relative to full scale of
0.5 V (in terms of dB full scale).
Return values:
<Peak>
Example:
Usage:
[:SOURce<hw>]:BB:POWer:RMS?
This command queries the power of the baseband signal relative to full scale of 0.5V
(in terms of dB full scale).
Return values:
<Rms>
Example:
Usage:

11.14.9 SOURce:CORRection Subsystem

The output level is corrected in the CORRection subsystem. Correction is performed
by user-defined table values being added to the output level for the respective RF fre-
quency. In the R&S SGT, this subsystem is used to select, transfer and activate user
correction tables.
Each list is stored as a file. The name of the user correction file can be freely selected.
The file extension *.uco is assigned automatically and cannot be changed.
The files can be stored in a freely selectable directory and opened from there. The
default directory is set using command
case of files which are stored in the default directory, only the file name has to be
specified in commands. Otherwise, the complete absolute path has to be specified with
every command. The extension can be omitted in any case.
User Manual 1176.8674.02 ─ 07
float
Range: -145 to 30
Increment: 0.01
*RST: 0
Default unit: dBfs
BB:POW:PEAK
queries the peak power of the baseband signal.
Query only
float
Range: -145 to 30
Increment: 0.01
*RST: 0
Default unit: dBfs
BB:POW:RMS
queries the power of the baseband signal.
Query only
:MMEMory:CDIRectory
Remote Control Commands
SOURce Subsystem
on page 322. In the
414