Frequency/ Phase - R&S SGT100A User Manual

®
R&S SGT100A
Remote command:
[:SOURce]:OPMode

7.7.3 Frequency/ Phase

The frequency and phase related settings are provided in the "Frequency/Phase" dia-
log.
► To access this dialog, select "SGMA-GUI > Instrument Name > RF > Frequency/
Phase".
Configuring the RF frequency
1. To change the RF frequency of the selected instrument, perform one of the follow-
ing:
a) Select "SGMA-GUI > Instrument Name > Frequency/Phase > Frequency" and
b) Select "SGMA-GUI main panel > Freq" and set the frequency.
2. To enable frequency offset for example to consider the frequency shift of a down-
stream instrument, set the parameter "Frequency/Phase > Offset".
Changes of the RF frequency have an immediate effect on the output signal.
Frequency
Sets the RF frequency at the RF output connector of the selected instrument.
The displayed value does not consider an enabled frequency offset (Offset).
Remote command:
See
Offset
Sets a frequency offset.
User Manual 1176.8674.02 ─ 07
on page 341
set the frequency at the RF output.
The value includes possible frequency offset.
[:SOURce]:FREQuency[:CW|FIXed]
Signal Generator Settings
on page 340
RF Settings
199