Connector Subsystem - R&S SGT100A User Manual

®
R&S SGT100A
Usage:
Manual operation:
:CLOCk:INPut:SLOPe <Slope>
The command sets the active slope of an externally applied clock signal at the USER
1/2 connector.
Parameters:
<Slope>
Example:
:CLOCk:OUTPut:MODE <Mode>
The command sets the output of bit or symbol clock pulses at the USER 1/2 connector
at the rear panel.
Parameters:
<Mode>
Example:

11.6 CONNector Subsystem

:CONNector:REFLo:OUTPut
:CONNector:USER<ch>:OMODe
:CONNector:USER<ch>:THReshold
:CONNector:USER<ch>:CLOCk:IMPedance
:CONNector:USER<ch>:TRIGger:IMPedance
:CONNector:USER<ch>:CLOCk:SLOPe
:CONNector:USER<ch>:TRIGger:SLOPe
:CONNector:REFLo:OUTPut <Output>
Determines the signal provided at the output connector REF/LO OUT (rear of the
instrument).
Parameters:
<Output>
Manual operation:
User Manual 1176.8674.02 ─ 07
Query only
See "Measured External Clock"
NEGative | POSitive
*RST: POSitive
CLOC:INP:SLOP NEG
The active slope of the external clock signal is the falling slope.
SYMBol | BIT
*RST: SYMBol
CLOC:OUTP:MODE SYMB
The internal symbol clock is output.
........................................................................................... 314
.....................................................................................315
................................................................................ 315
.....................................................................316
................................................................... 316
...........................................................................316
.........................................................................316
REF | LO | OFF
*RST: REF
See "REF/LO Output"
Remote Control Commands
CONNector Subsystem
on page 122
on page 202
314