R&S SGT100A User Manual page 187

®
R&S SGT100A
If the V
●
If 0 < V
●
If V
For the previous example, if V
Example: Calculating the current V
In "Envelope Voltage Adaptation > Manual" mode, set the parameter "Pre-Gain = PEP
= - 3.4 dB".
The displayed shaping function resembles the shaping function in "Auto Normalized"
mode; the same formulas apply, too.
You can also query the V
tion mode and units.
See
on page 440.
Additional information
The described principle applies for any shaping function.
User Manual 1176.8674.02 ─ 07
value is changed (V
cc,min
≤ V
/V
in in,max cc,min
/V > V , then V
in in,max cc,min
CC
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:ENVelope:VCC:VALue?
Generation of Envelope Tracking Signals
> 0 V), then the following applies:
cc,min
, the signal is clipped and V
Norm = V /V
cc in in,max
= 200 mV, that V
cc,min
in "Manual" mode
CC
values for any specified x in the supported voltage adapta-
Signal Generator Settings
Norm = V
cc cc,min
Norm = V = 0.2 V.
cc cc,min
156