Fast Speed Commands - R&S SGT100A User Manual

®
R&S SGT100A
Note: Instruments with Linux operating system ignore this command, since Linux does
not use drive letter assignment.
Usage:
:MMEMory:RDIRectory <Directory>
Removes an existing directory from the mass memory storage system. If no directory
is specified, the subdirectory with the specified name is deleted in the default directory.
Setting parameters:
<Directory>
Usage:
:MMEMory:STORe:STATe <savrcl_state_nr>, <file_name>
Stores the current instrument setting in the specified file.
The instrument setting must first be stored in an internal memory with the same num-
ber using the common command *SAV.
Setting parameters:
<savrcl_state_nr>
<file_name>
Usage:

11.10 Fast Speed Commands

This section describes special commands that allow a fast frequency and level setting.
:FFASt
:PFASt
:FFASt <Freq>
Special command to set the RF output frequency with minimum latency. No unit (e.g.
Hz) allowed.
Bypasses the status system so command *OPC? cannot be appended.
Parameters:
<Freq>
Example:
User Manual 1176.8674.02 ─ 07
SCPI confirmed
string
String parameter to specify the directory to be deleted.
Event
Corresponds to the specific <number> defined with the *SAV
command, e.g. *SAV 4.
String parameter to specify the file name with extension
*.savrcltxt.
Event
.......................................................................................................................... 326
.......................................................................................................................... 327
float
FFASt 12750000000
Remote Control Commands
Fast Speed Commands
326