[:Source<Hw>]:Bb:arbitrary:wsegment:configure:marker:mode; [:Source<Hw>]:Bb:arbitrary:wsegment:configure:ofile - R&S SGT100A User Manual

®
R&S SGT100A
Parameters:
<Mode>
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:MODE <Mode>
Defines the way the marker information within the separate segments is processed.
Parameters:
<Mode>
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe <OFile>
Defines the file name for the multi segment waveform. The file extension is *.wv.
Parameters:
<OFile>
Example:
User Manual 1176.8674.02 ─ 07
OFF | MRK1 | MRK2 | MRK3 | MRK4
OFF
No additional marker is generated.
MRK1|MRK2|MRK3|MRK4
Generates a restart marker signal at the beginning of the first
segment for the corresponding marker.
Use this setting to generate a restart marker for the complete
sequence.
*RST: OFF
BB:ARB:WSEG:CONF:SEL 'ConfComm'
BB:ARB:WSEG:CONF:MARK:FSEG MRK3
See " Sequence Restart "
IGNore | TAKE
IGNore
The marker information carried in the individual segment wave-
form files is not considered.
TAKE
The output waveform file contains the marker information as
configured in the individual waveform files.
*RST: TAKE
BB:ARB:WSEG:CONF:SEL 'ConfComm'
BB:ARB:WSEG:CONF:MARK:MODE TAKE
See " Segment Marker "
string
MMEM:CDIR '/var/user/waveform'
sets the default directory.
BB:ARB:WSEG:CONF:SEL 'multi1'
creates the configuration file multi1.inf_mswv in default
directory.
BB:ARB:WSEG:CONF:OFIL 'mseg1_2'
defines the file name mseg1_2.wv for the multi segment wave-
form file created using configuration file multi1.inf_mswv.
Remote Control Commands
SOURce Subsystem
on page 90
on page 90
395