Rf Level Settings - R&S SGT100A User Manual

®
R&S SGT100A
7.7.6.1

RF Level Settings

► To access the RF level settings, select "SGMA-GUI > Instrument Name > RF >
Level > RF Level".
This dialog comprises settings like the RF level and level limit.
Level/Level Offset
Sets the RF level at the RF output connector of the selected instrument.
If you set a digital attenuation, while "I/ Q Mod > Modulation Source > Internal Base-
band" and "I/ Q Mod > Modulation State > ON", it will be indicated in the R&S SGMA-
GUI main panel by a change in the name of this parameter from "Level" to "Level Off-
set".
Note: The SCPI command
AMPLitude]
set while
Remote command:
[:SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude]
[:SOURce]:POWer:POWer
Digital Attenuation
Available only for "I/Q Mod > State > On" and "I/Q Mod > Source > Internal Baseband".
User Manual 1176.8674.02 ─ 07
[:SOURce]:POWer[:LEVel][:IMMediate][:
sets the level of the "Level" display, that means the level containing off-
[:SOURce]:POWer:POWer
on page 468
Signal Generator Settings
sets the level at the RF output connector.
RF Settings
on page 468
206