Maintenance - R&S SGT100A User Manual

®
R&S SGT100A
Security Password ← Security Settings
Enters the password that is required to enable or to disable the settings protected by a
security password. The default is '123456'.
Note: It is highly recommended to change the default security password before con-
necting the instrument to the network. To change the security password, select
"SGMA-GUI > Instrument Name > Setup > Security > Change Security Password".
The settings are only accepted after the "Accept" button is pressed.
Accept ← Security Settings
Accept a new entry or selection and change the settings accordingly.

8.8 Maintenance

The R&S SGT provides a special dialog for performing some maintenance procedures,
like installing firmware packages.
► To access this dialog, select "SGMA-GUI > Instrument Name > Setup > Mainte-
nance".
Operation
Selects the desired maintenance operation.
"Install firm-
ware package"
"Initialize SSD" Formats the solid-state disk (SSD).
Select Package
Available only for "Operation > Install Firmware Package".
Selects the firmware package to be installed, see also
New Firmware Version on the
Update All
Available only for "Operation > Install Firmware Package".
Enable this function to perform a simultaneous firmware update on all instruments, that
are in active state and are connected to this controller.
User Manual 1176.8674.02 ─ 07
General Instrument Settings and Instrument Setup
Installs a selected firmware package.
Instrument",
Chapter 9.9, "How to Install a
on page 272.
Maintenance
255