R&S SGT100A User Manual page 484

®
R&S SGT100A
[:SOURce<hw>]:IQ:DPD:OUTPut:ITERations:MAX <MaxIterations>
Sets the maximum number of performed iterations to achieving the required error set
with [:SOURce<hw>]:IQ:DPD:OUTPut:ERRor:MAX.
Parameters:
<MaxIterations>
Example:
[:SOURce<hw>]:IQ:DPD:MEASurement:STATe?
Queries whether the interactions are competed.
Return values:
<MeasureValidity>
Example:
Usage:
[:SOURce<hw>]:IQ:DPD:INPut:CFACtor?
[:SOURce<hw>]:IQ:DPD:OUTPut:CFACtor?
[:SOURce<hw>]:IQ:DPD:INPut:LEVel?
[:SOURce<hw>]:IQ:DPD:OUTPut:LEVel?
[:SOURce<hw>]:IQ:DPD:INPut:PEP?
[:SOURce<hw>]:IQ:DPD:OUTPut:PEP?
Queries the measured values the before and after the enabled digital predistortion.
Return values:
<PEP>
Example:
Usage:
Manual operation:
[:SOURce<hw>]:IQ:DPD:PIN:MIN <PepInMin>
[:SOURce<hw>]:IQ:DPD:PIN:MAX <PepInMax>
Sets the value range of the input power.
User Manual 1176.8674.02 ─ 07
integer
Range: 1 to 10
*RST: 3
See Example "Defining correction coefficients and enabling digi-
tal predistortion" on page 447
0 | 1 | OFF | ON
*RST: 1
See Example "Defining correction coefficients and enabling digi-
tal predistortion" on page 447
Query only
float
The query returns -1000 if the calculation is impossible or there
are no measurements results available.
see Example "Defining correction coefficients and enabling digi-
tal predistortion" on page 447
Query only
See "Input/Output PEP, Level and Crest Factor"
Remote Control Commands
SOURce Subsystem
on page 187
453