Trigger Settings - R&S SGT100A User Manual

®
R&S SGT100A
Parameters:
<Mode>
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:CLOCk:SYNChronization:EXECute
Performs automatically adjustment of the instrument's settings required for the syn-
chronization mode, set with the command
SYNChronization:MODE.
Example:
Usage:
11.14.4.3

Trigger Settings

The TRIGger subsystem contains the commands for setting the trigger.
For option R&S SGT-K540, the ARB waveform for the envelope tracking (SOURce2)
uses the same trigger settings as the first ARB waveform (SOURce1). Therefore these
commands are not defined for SOURce2.
[:SOURce<hw>]:BB:ARBitrary:TRIGger:ARM:EXECute
[:SOURce<hw>]:BB:ARBitrary:TRIGger:EXECute
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal]:SYNChronize:OUTPut
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay:MAXimum?
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay:MINimum?
[:SOURce<hw>]:BB:ARBitrary:TRIGger:RMODe?
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SLENgth
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SLUNit
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SMODe
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SOURce
[:SOURce<hw>]:BB:ARBitrary:TRIGger:DELay:UNIT
User Manual 1176.8674.02 ─ 07
NONE | MASTer | SLAVe | DIIN
NONE
The instrument is working in stand-alone mode.
MASTer
The instrument provides all connected instrument with its syn-
chronisation (including the trigger signal) and reference clock
signal.
SLAVe
The instrument receives the synchronisation and reference clock
signal from another instrument working in a master mode.
DIIN
The instrument receives the synchronisation and reference clock
signal from the DIGITAL I/Q connector.
*RST: NONE
See "Sync Mode" on page 121
[:SOURce<hw>]:BB:ARBitrary:CLOCk:
BB:ARB:CLOC:SYNC:MODE MAST
the instrument is configured to work as a master one.
BB:ARB:CLOC:SYNC:EXEC
all synchronization's settings are adjusted accordingly.
Event
............................................................. 356
............................................................. 357
..............................................................358
................................................................ 359
............................................................... 359
..............................................................359
Remote Control Commands
SOURce Subsystem
..................................................... 356
.......................... 356
........................... 357
.............................357
........................................................ 360
355