Source:bb:power Subsystem - R&S SGT100A User Manual

®
R&S SGT100A
Example: Querying the status of the Create Waveform file process
The following is an example on how to use these commands to retrieve information
about how many percent of the initiated process are completed.
[:SOURce<hw>]:BB:PROGress:MCODer?
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:MCARrier?
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:WSEGment?
[:SOURce<hw>]:BB:PROGress:MCODer?
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:MCARrier?
[:SOURce<hw>]:BB:PROGress:MCODer:ARBitrary:WSEGment?
Queries the status of an initiated process, like for example the calculation of a signal in
accordance to a digital standard, or the calculation of a multi-carrier or multi-segment
waveform file.
Return values:
<WSegment>
Example:
Usage:

11.14.8 SOURce:BB:POWer Subsystem

This subsystem contains the commands for retrieving the level values of the digital
baseband signal.
[:SOURce<hw>]:BB:CFACtor?
This command queries the crest factor of the baseband signal.
Return values:
<CFactor>
Example:
Usage:
User Manual 1176.8674.02 ─ 07
........................................................................413
integer
Indicates the task progress in percent
Range: 0 to 100
*RST: 100
See Example "Querying the status of the Create Waveform file
process" on page 413
Query only
float
Range: 0 to 100
Increment: 0.01
*RST: 0
Default unit: dB
BB:CFAC
queries the crest factor of the baseband signal.
Query only
Remote Control Commands
SOURce Subsystem
..........................................413
.......................................413
413