R&S SGT100A User Manual page 388

®
R&S SGT100A
Parameters:
<Output>
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay:MAXimum?
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay:MINimum?
The command queries the minimum marker delay for set-
ting :BB:ARB:TRIGger:OUTPut:DELay:FIXed ON.
Return values:
<Minimum>
Example:
Usage:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:RMODe?
The command queries the status of waveform output or all trigger modes with ARB on.
User Manual 1176.8674.02 ─ 07
0 | 1 | OFF | ON
ON
The signal calculation starts simultaneously with the external
trigger event but because of the instrument's processing time
the first samples are cut off and no signal is outputted. After
elapsing of the internal processing time, the output signal is syn-
chronous to the trigger event.
OFF
The signal output begins after elapsing of the processing time
and starts with sample 0, i.e. the complete signal is outputted.
This mode is recommended for triggering of short signal sequen-
ces with signal duration comparable with the processing time of
the instrument.
*RST: ON
BB:ARB:TRIG:SOUR EXT
sets external triggering.
BB:ARB:TRIG:EXT:SYNC:OUTP ON
enables synchronous output to external trigger
See "Sync. Output to External Trigger"
float
Range: 0 to 16777215
Increment: 1E-3
*RST: 0
BB:ARB:TRIG:OUTP:DEL:FIX ON
restricts the marker signal delay setting range to the dynamic
range.
BB:ARB:TRIG:OUTP:DEL:MIN
queries the minimum of the dynamic range.
Response: 0
the minimum for the marker delay setting is 0 samples.
Query only
See "Current Range without Recalculation"
Remote Control Commands
SOURce Subsystem
on page 112
on page 121
357