R&S SGT100A User Manual page 64

®
R&S SGT100A
LAN CONNECTOR
The LAN (Ethernet) interface allows you to connect the R&S SGT to other devices like
a remote computer. On the computer, you can perform a firmware update, manual
operation via the R&S SGMA-GUI software or for remote control of the instrument. The
connection to the remote computer can be direct or via a network.
For details, see
DIGITAL I/Q
Input of a digital I/Q signal.
USER 1/2
Multi-purpose connectors. The input/output signal has to be defined, e.g. "Trigger",
"Marker 1/2", "Clock In/Out", "Sync In/Out".
USER 1 is an SMB connector while USER 2 is an SMA female connector.
Connector USER 2 can be also used as an input for external pulse modulator sources.
RF OUT
Provides an RF 50 Ohm signal output.
NOTICE! Maximum input levels. Do not overload the RF output. The maximum permis-
sible back-feed is specified in the data sheet.
User Manual 1176.8674.02 ─ 07
Chapter 2.3.2, "Connecting a Remote PC via
Instrument Tour
Rear Panel Tour
LAN", on page 26.
33