R&S SGT100A User Manual page 461

®
R&S SGT100A
Parameters:
<Type>
Example:
Manual operation:
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:COUPling[:STATe] <State>
Couples the bias setting of the I and Q signal components.
Parameters:
<State>
Example:
Manual operation:
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:I <I>
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:Q <Q>
Specifies the amplifier bias of the respective I- or Q- component.
The maximum overall voltage depends on the I/Q output type.
See
Parameters:
<Q>
Example:
Manual operation:
[:SOURce<hw>]:IQ:OUTPut:LEVel <Level>
Sets the off-load voltage of the analog I/Q signal output.
The value range and maximum overall voltage vary, depending on the I/Q output type.
See
Parameters:
<Level>
User Manual 1176.8674.02 ─ 07
SINGle | DIFFerential
*RST:
SOURce1:IQ:OUTPup:ANALog:TYPE DIFFerential
See
0 | 1 | OFF | ON
*RST:
IQ:OUTP:BIAS:COUP ON
Activates I/Q bias coupling.
See
Table 7-4.
float
Range:
Increment: 0.002
*RST:
IQ:OUTP:BIAS:Q 0.1 V
See
Table 7-4.
float
Range:
Increment: 0.001
*RST:
SINGle
"I/Q Output Type" on page 143
0
"Couple I/Q Bias" on page 144
-3.6 to 3.6
0
"Bias (EMF)" on page 144
0.02 to 4
1
Remote Control Commands
SOURce Subsystem
430