R&S SGT100A User Manual page 334

®
R&S SGT100A
Connecting and configuring the monitoring PCs
In the "Setup > Security > Security Settings" dialog, check the state of the LAN and
USB interfaces and enable them if necessary.
1. Connect the monitoring PC to the instrument.
Note: Choose the hardware interface considering the limitations described in
Table
2. Configure the instrument in the R&S SGMA-GUI, see
Instruments in the R&S
3. In the "SGMA-GUI > Setup > Instruments > Edit Instruments" dialog, disable
"Exclusive Access".
Note: The two functions "Exclusive Access" and monitoring are mutually exclusive.
4. Send remote control commands from the controller to the instrument.
5. Open the corresponding dialogs in the R&S SGMA-GUI. Observe the status of the
parameters.
User Manual 1176.8674.02 ─ 07
Using the R&S SGMA-GUI to Monitor the Remote Control Operation
10-2.
SGMA-GUI",
Network and Remote Control Operation
Chapter 6.5.2, "Handling
on page 63.
303