Rect Test Signal - R&S SGT100A User Manual

®
R&S SGT100A
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:PHASe
Generate Signal File
Generates a signal and saves it to a file.
The "File Select" window opens automatically and the signal can be stored as a wave-
form file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate:NAMed
on page 366
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate:NAMed
Generate Signal RAM
Generates a signal and uses it as output straight away.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate
7.1.2.6

Rect Test Signal

This dialog provides settings for configuration of a rectangular test signal. A rectangu-
lar test signal with a duty factor of 0.5 is created. Amplitude and offset are adjustable.
Both paths, I and Q, use the same signal.
Frequency
Enters the frequency of the test signal.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:FREQuency
Samples per Period
Enters the number of sample values required for the rectangular signal per period.
The maximum allowed value is determined by the maximum ARB clock rate (see data
sheet) and the selected frequency.
User Manual 1176.8674.02 ─ 07
Signal Generator Settings
Baseband
on page 368
on page 366
on page 366
on page 366
on page 366
on page 366
on page 367
107