R&S SGT100A User Manual page 205

®
R&S SGT100A
The shaping table files are files with predefined extension and file format, see
mat of the shaping table file"
You can create a shaping table externally or internally.
"Select"
"New"
"Edit"
Remote command:
In "Envelope Voltage Adaptation
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:ENVelope:SHAPing:FILE:CATalog?
on page 443
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:ENVelope:SHAPing:FILE[:SELect]
on page 443
In "Envelope Voltage Adaptation
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:ENVelope:SHAPing:PV:FILE:
CATalog?
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:ENVelope:SHAPing:PV:FILE[:
SELect]
Interpolation
Enabled in "Shaping > From Table".
An envelope shaping function defined in a table contains a limited number of value
pairs. This parameter enables a linear interpolation between the defined values to pre-
vent abrupt changes.
Table 7-10: Effect of parameter "Interpolation"
"Interpolation > Off"
Remote command:
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:ENVelope:SHAPing:INTerp
on page 444
Graphic Configuration
Comprises setting to configure the graphical display.
User Manual 1176.8674.02 ─ 07
on page 151.
Selects and loads an existing file
Creates a file
Access a standard built-in table editor, see
Envelope Shape
on page 443
on page 443
Generation of Envelope Tracking Signals
Settings", on page 175.
> Manual" mode:
> Auto" mode:
"Interpolation > Linear Voltage"
Signal Generator Settings
"File for-
Chapter 7.5.6, "Edit I/Q
174