[:Source<Hw>]:Bb:arbitrary:mcarrier:edit:carrier:phase[:Start]; [:Source<Hw>]:Bb:arbitrary:mcarrier:edit:carrier:power:step; [:Source<Hw>]:Bb:arbitrary:mcarrier:edit:carrier:power[:Start] - R&S SGT100A User Manual

®
R&S SGT100A
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:PHASe[:STARt] <Start>
The command sets the start phase for the individual carriers in the defined carrier
range. If the command :BB:ARB:MCAR:EDIT:CARR:PHAS:STEP is used to define a
step width, the phase entered here applies only to the starting carrier. The phases of
the remaining carriers are stepped up or down by the phase value specified in
the :BB:ARB:MCAR:EDIT:CARR:PHAS:STEP command.
The phase settings are only valid if optimization of the crest factor is disabled
(:SOURce:BB:ARB:MCARrier:CFACtor:MODE OFF).
Parameters:
<Start>
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer:STEP <Step>
The command sets the step width by which the starting power of the carriers in the
defined carrier range will be incremented.
Parameters:
<Step>
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer[:STARt] <Start>
The command sets the power for the individual carriers in the defined carrier range. If
the command :BB:ARB:MCAR:EDIT:CARR:POW:STEP is used to define a step width,
the power entered here applies only to the starting carrier. The power of the remaining
carriers is stepped up or down by the power specified in
the :BB:ARB:MCAR:EDIT:CARR:POW:STEP command.
User Manual 1176.8674.02 ─ 07
float
Range: 0 to 359.99
Increment: 0.01
*RST: 0
Default unit: DEG
BB:ARB:MCAR:EDIT:CARR:PHAS 90 DEG
sets a start phase of 90° for the carriers in the carrier range.
See " Phase Start " on page 102
float
Range: -80 to 80
Increment: 0.01
*RST: 0
Default unit: dB
BB:ARB:MCAR:EDIT:CARR:POW -80dB
sets a power of -80 dB for the carriers in the carrier range.
BB:ARB:MCAR:EDIT:CARR:POW:STEP 1 dB
the power is incremented by 1dB for each carrier, i.e. the first
carrier has -80dB, the second -79dB, etc.
See " Gain Step " on page 102
Remote Control Commands
SOURce Subsystem
379