R&S SGT100A User Manual page 146

®
R&S SGT100A
been output (wrap around). In this case the signal transition is seamless. As a pre-
requisite for a seamless switchover, all segments must have the same sample rate.
The following figure shows an example of the seamless transition from a sinewave
signal segment to a sawtooth segment (I channel, above) in the case of next seg-
ment external triggering (below).
The regular trigger mode for starting the waveform generation and triggering the
whole multi segment sequence is set with the parameters in the "Trigger In" section
of the "Trigger/Marker/Clock" dialog.
The segment currently being output is displayed at "Current Segment".
The "Trigger Example" graph displays schematically the waveform output, depending
on the activated trigger and the next segment settings.
User Manual 1176.8674.02 ─ 07
Signal Generator Settings
Baseband
115