R&S SGT100A User Manual page 117

®
R&S SGT100A
Save List
Saves the current entries of the table in a configuration file, including the level mode,
clock mode, segment marker mode and output filename settings.
The filename is entered in the "File" menu. Configuration files have the file extension
*.inf_mswv. They can be used later as the basis for further multi segment wave-
forms.
Before a multi segment configuration file can be saved, a filename must be entered in
"Output File", since this is saved with the configuration file for internal purposes.
Remote command:
The configuration file to be used for the creation of the multi segment waveform is
defined with the command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CREate
The filename of the waveform file is always determined with the command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe
Create
Creates a new multi segment waveform using the current table entries.
This multi segment waveform is saved with the filename specified in "Output File". As
with normal waveforms, the file extension is "*.wv".
Depending on the configuration of the multi segment waveform, calculation may take
some time. A panel with a progress bar and an "Abort" button appears during creating
of the multi segment waveform.
In remote control the configuration file to be used for the creation of the multi segment
waveform is defined with the
WSEGment:CREate
The filename of the waveform file is always determined with the command
SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CREate
Create and Load
Creates a new multi segment waveform using the current table entries.
This multi segment waveform is saved with the filename specified in "Output File". As
with normal waveforms, the file extension is *.wv.
Depending on the configuration of the multi segment waveform, calculation may take
some time.
Following this the "Create Multi Segment Waveform File" submenu is closed and the
new multi segment waveform is loaded.
In remote control the configuration file to be used for the creation of the multi segment
waveform is defined with the
WSEGment:CREate
The filename of the waveform file is always determined with the command
SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad
User Manual 1176.8674.02 ─ 07
command:[:SOURce<hw>]:BB:ARBitrary:
or [:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad.
command:[:SOURce<hw>]:BB:ARBitrary:
or [:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad.
Signal Generator Settings
Baseband
[:
on page 397
[:
on page 390
86