R&S SGT100A User Manual page 333

®
R&S SGT100A
Table 10-2: Cross-reference between used remote channels and collision-free communication
Monitor/
Controller
LAN (VXI-11)
LAN (HiSLIP)
USB
LAN (Socket)
PCIe
Where:
●
OK: communication possible, no collisions
*) the R&S SGMA-GUI always uses the LAN device name instr1, see also
ter 10.1.2.3, "VXI-11
●
X: communication is not possible without collisions
●
viLock/viUnlock: communication is only possible, if the remote control com-
mands are enclosed in a viLock () - viUnlock() pair.
The R&S SGMA-GUI uses the viLock()/viUnlock() functions.
The figure below shows an example of configuration where the monitor and the con-
troller are two different computers, connected to the same instrument over two different
hardware interfaces.
Figure 10-5: Example of a setup for remote control monitoring
User Manual 1176.8674.02 ─ 07
Using the R&S SGMA-GUI to Monitor the Remote Control Operation
LAN LAN (HiSLIP)
(VXI-11)
OK* OK
OK OK
OK OK
OK OK
OK OK
Protocol", on page 282.
Network and Remote Control Operation
USB LAN (Socket)
OK OK
OK OK
viLock/viUnlock OK
OK X
OK OK
PCIe
OK
OK
OK
OK
X
Chap-
302