[:Source<Hw>]:Bbin:mode; [:Source<Hw>]:Bbin:mperiod; [:Source<Hw>]:Bbin:offset:i; [:Source<Hw>]:Bbin:offset:q - R&S SGT100A User Manual

®
R&S SGT100A
[:SOURce<hw>]:BBIN:MODE <Mode>
This command selects the external input signal mode for the "Baseband In" block.
Parameters:
<Mode>
Example:
[:SOURce<hw>]:BBIN:MPERiod <MPeriod>
Sets the recording duration for measuring the baseband input signal by Auto Level Set.
Parameters:
<MPeriod>
Example:
Manual operation:
[:SOURce<hw>]:BBIN:OFFSet:I <I>
[:SOURce<hw>]:BBIN:OFFSet:Q <Q>
This command enters a DC offset to the Q component of the external baseband signal.
Parameters:
<Q>
User Manual 1176.8674.02 ─ 07
ANALog | DIGital
ANALog
The external analog baseband signal is supplied via the inputs I
and Q.
DIGItal
The external digital baseband signal is fed into the signal path
via the "Digital Input" connector. The internal signal processing
is based on a sample rate of 100 MHz. Input signals with a sam-
ple rate less than 100 MHz are upsampled. The sample rate can
be estimated or defined by the user in the appropriate entry
fields.
*RST: ANALog
BBIN:SOUR ANAL
selects an external analog signal as the input signal. The signal
must be applied at the inputs I and Q.
integer
Range: 1 to 32
*RST: 2
Default unit: s
BBIN:MPER 4s
sets the recording duration for Auto Level Set to 4 seconds.
See "Measurement Period"
float
Range: -10 to 10
Increment: 0.001
*RST: 0
Default unit: %FS
Remote Control Commands
SOURce Subsystem
on page 240
403