R&S SGT100A User Manual page 387

®
R&S SGT100A
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal<1|2>]:DELay
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal<1|2>]:TDELay
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal<1|2>]:RDELay?
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal<1|2>]:INHibit
[:SOURce<hw>]:BB:ARBitrary[:TRIGger]:SEQuence
[:SOURce<hw>]:BB:ARBitrary:TRIGger:ARM:EXECute
The command stops waveform output for trigger modes Armed_Auto and Armed_Ret-
rigger. A subsequent internal or external trigger event restart waveform output.
Example:
Usage:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:EXECute
The command executes a trigger. The internal trigger source must be selected using
the command ARB:TRIGger:SOURce INTernal and a trigger mode other than
AUTO must be selected using the command :ARB:SEQuence.
Example:
Usage:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal]:SYNChronize:OUTPut
(enabled for "Trigger Source" External)
Enables/disables output of the signal synchronous to the external trigger event.
User Manual 1176.8674.02 ─ 07
BB:ARB:TRIG:SOUR INT
sets internal triggering.
BB:ARB:TRIG:SEQ ARET
sets Armed_Retrigger mode, i.e. every trigger event causes
waveform output to restart.
BB:ARB:TRIG:EXEC
executes a trigger, waveform output is started.
BB:ARB:TRIG:ARM:EXEC
waveform output is stopped.
BB:ARB:TRIG:EXEC
executes a trigger, waveform output is started again.
Event
See "Arm"
BB:ARB:TRIG:SOUR INT
sets internal triggering.
BB:ARB:SEQ RETR
sets Retrigger mode, i.e. every trigger event causes signal out-
put to restart.
BB:ARB:TRIG:EXEC
executes a trigger.
Event
See "Execute Trigger"
<Output>
......................................................... 361
on page 111
on page 111
Remote Control Commands
SOURce Subsystem
........................................ 360
.......................................360
.................................... 360
........................................ 361
356