R&S SGT100A User Manual page 500

®
R&S SGT100A
Parameters:
<Amplitude>
Manual operation:
[:SOURce]:POWer[:LEVel][:IMMediate]:OFFSet <Offset>
Specifies the constant level offset of a downstream attenuator/amplifier. If a level offset
is entered, the level entered with :POWer no longer corresponds to the RF output
level.
The following correlation applies:
:POWer = RF output level + POWer:OFFSet.
Entering a level offset does not change the RF output level, but rather the query value
of :POWer.
Only dB is permitted as the unit here. The linear units (V, W, etc.) are not permitted.
Parameters:
<Offset>
Manual operation:
[:SOURce]:POWer:RANGe:LOWer?
[:SOURce]:POWer:RANGe:UPPer?
Queries the minimum/maximum level range in the current level mode
Return values:
<Upper>
Usage:
Manual operation:
[:SOURce]:POWer:WIGNore <State>
Ignores level range warnings.
Parameters:
<State>
Example:
User Manual 1176.8674.02 ─ 07
float
Range: -120 to 25
Increment: 0.01
*RST: -10
Default unit: dBm
See "Level/Level Offset"
float
Range: -100 to 100
Increment: 0.1
*RST: 0
See "Offset" on page 207
float
Query only
See "Level Range" on page 208
0 | 1 | OFF | ON
*RST: 0
POW:WIGN ON
suppresses the level range warnings.
Remote Control Commands
SOURce Subsystem
on page 60
469