Nrp Power Viewer - R&S SGT100A User Manual

®
R&S SGT100A
Scan
Scans the network and the USB connections for sensors connected via the VISA com-
munication protocol, i.e. sensors that are addressed via LAN or USBTMC.
Sensors communicating via the USB legacy protocol are detected automatically.
Remote command:
:SLISt:SCAN[:STATe]

7.7.8 NRP Power Viewer

The R&S SGT features the power viewer function for measuring or monitoring signals
with R&S NRP power sensors.
The R&S SGT can perform up to four power measurements simultaneously. The mea-
sured signals can be the RF output power or other selected signal sources.
Connecting R&S NRP power sensors to the R&S SGT
R&S NRP sensors are connected to the R&S SGT in the following ways:
●
Connection to the USB connector via adapter cable
Required are the following cables:
–
–
●
Connection via R&S NRP-Z5 sensor hub
Additional cables are required, see
●
Connection via USB hub with external power supply unit
Additional cables are required, see
Using the R&S NRP-Z5 sensor hub
The R&S NRP-Z5 USB sensor hub (high-speed USB 2.0) can host up to 4 R&S NRP
sensors. It provides simultaneous internal and external triggering of all connected sen-
sors.
Figure 7-25
R&S
Figure 7-25: Connecting power sensors to the R&S SGT via R&S NRP-Z5 sensor hub
I, II =
G = Signal source (R&S SGT)
1 = USB type Micro-A connector
User Manual 1176.8674.02 ─ 07
on page 339
Adapter cable: R&S NRP-Z3 or R&S NRP-Z4
USB Adapter Micro-A to A
illustrates the connection as principle. For details, see the description
® ®
NRP Series Power Sensors getting started.
Connection order
Signal Generator Settings
Using the R&S NRP-Z5 sensor
Using USB hub.
RF Settings
hub.
221