Keyboard Tests; Simulation - R&S SGT100A User Manual

®
R&S SGT100A
Execute Connection Test
Performs a connection test between the connectors USER1 and USER2.
Remote command:
:TEST:BB:CONNection?

8.15.3 Keyboard Tests

Access:
► Select "SGMA-GUI > Instrument Name > Diagnostic Tests > Keyboard Test".
Use this function to check the proper operation of all front panel elements.
If "Keyboard Test" is enabled, all front panel LEDs except the POWER ON are orange.
The exact test procedure is described in the service manual.
SCPI command:
:TEST:KEYBoard[:STATe]

8.15.4 Simulation

This is a protected function that can be used only in simulation mode. This function
cannot be used with a physical instrument.
Access:
1. In the SGMA-GUI, create a virtual R&S SGT instrument:
a) Select "SGMA-GUI > Setup > Instruments > New".
b) Select "Instrument Type = SGT".
All other settings are insignificant.
2. Select "SGMA-GUI > Setup > Protection".
3. Enter the "Protection Level 1" password 123456.
User Manual 1176.8674.02 ─ 07
General Instrument Settings and Instrument Setup
on page 489
on page 489
Diagnostic and Tests
264