R&S SGT100A User Manual page 112

®
R&S SGT100A
The output is based on the waveform file that is loaded. The name of the waveform file
is displayed next to "Load Waveform".
If a multi-segment waveform is loaded, the section "Multi Segment Waveform Options"
is indicated. In this section, the segment to be output is selected.
If no waveform file is loaded, ARB modulation cannot be powered up. "None" is dis-
played next to "Load Waveform". An error message asks the user to load a waveform
file:
"No waveform file loaded. ARB MOD state remains off. Please select a waveform file
to load, before switching ARB MOD state on."
Remote command:
[:SOURce<hw>]:BB:ARBitrary:STATe
Set To Default
Calls default settings. The values are shown in
Table 7-2: Default settings
Parameter
State
Clock Freq.
Trigger Mode
Trigger Source
Marker State
Marker Mode
Clock Source
Remote command:
[:SOURce<hw>]:BB:ARBitrary:PRESet
Waveform Location
Selects the location of the waveform that you want to load.
"Instrument"
"Local file system"
Load Waveform
Calls the "File Select" menu for loading the waveform file.
User Manual 1176.8674.02 ─ 07
The waveform file is located on the instrument's internal memory.
The waveform file is located on the local computer. In this case, the
waveform is first automatically copied on the instrument's internal
memory and then selected.
Note: To load a waveform from a USB memory stick (or external hard
disk) plug the stick into the controller PC, select "Waveform Location
> Local file system" and in the "Load Waveform" >"File Select" dialog
navigate to the external drive.
Signal Generator Settings
on page 352
Table 7-2.
Value
Off
1 MHz
Auto
Internal
Off
Unchanged
Internal
on page 352
Baseband
81