How To Switch Between The Operating States - R&S SGT100A User Manual

®
R&S SGT100A
Provided the network supports automatic assignment of IP address, new IP
address is automatically assigned to the instrument.

9.7 How to Switch between the Operating States

The
trigger the switch-over between them.
Figure 9-1: Operating states
"Setup > Standby", "Setup > Restart", "Shut Down
Instruments and Exit"
POWER ON/STANDBY, POWER SWITCH On/Off
The
Table 9-2: Indication of the operating states
Operating
state
Off
Booting
User Manual 1176.8674.02 ─ 07
Figure 9-1 gives an overview of the operating states of the instruments and how to
Table 9-2 provides a short description of the operating states and their indication.
Description
The instrument is shut down.
The instrument boots the operating system
and starts the instrument firmware.
If the previous session was terminated reg-
ularly, the instrument uses the last setup
with the relevant instrument settings.
Performing Configuration Tasks
How to Switch between the Operating States
= R&S SGMA-GUI controls
= Hardkey controls on the front/rear panel of the
instrument
Indication
All LEDs on the front panel of the instrument
are off.
The green POWER ON/STAND BY key blinks.
270