R&S SGT100A User Manual page 135

®
R&S SGT100A
No ← Carrier Table
Indicates the carrier index ranging from 0 to (number of carriers -1).
Individual carriers can be set using the remote control commands by specifying the
index in the parameter CARR.
State ← Carrier Table
Switches On/Off a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:STATe
Carrier Freq Offs. ← Carrier Table
Sets the carrier frequency offset.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:FREQuency
on page 372
Gain ← Carrier Table
Sets the gain of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:POWer
Phase ← Carrier Table
Sets the starting phase of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:PHASe
Delay ← Carrier Table
Sets the starting delay of a carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:DELay
File ← Carrier Table
Calls the "File" menu for selecting the input file with the I/Q signal to be modulated onto
the carrier.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:FILE
Info ← Carrier Table
Indicates the sample rate, number of I/Q value pairs (number of samples), and the
resulting signal period of the selected I/Q input file.
Remote command:
n.a.
!!! ← Carrier Table
Indicates an occurred conflict by means of a red LED. A conflict arises when the carri-
ers overlap.
User Manual 1176.8674.02 ─ 07
Signal Generator Settings
Baseband
on page 373
on page 373
on page 372
on page 371
on page 372
104