R&S SGT100A User Manual page 539

®
R&S SGT100A
Setting parameters:
[TRACE]
[#]
Pos
Val
Example:
Example:
Usage:
{WAVEFORM-Length: #I0Q0I1Q1...IxQx...IN-1QN-1...}
(mandatory for waveforms)
The tag contains the actual waveform data or multi-segment waveform data (I/Q
stream).
Setting parameters:
Length
User Manual 1176.8674.02 ─ 07
Specifies the name of the marker or control signal.
You can choose from the following names:
MARKER; BURST; LEVATT; CW MODE; HOP, MAP
Specifies the number in the case of control signals and marker
signals with the same name. There is a choice between 4 mark-
ers and 3 LEVATT signals. Lines LEVATT 1 and 2 are needed
for internal purposes and should not be used.
Specifies in ASCII format the number of the position in the
sequence, with effect from which the binary state of the marker
or of the control signal changes from 0 to 1 or from 1 to 0.
Specifies the binary state of the marker or of the control signal
{0; 1} from Pos to Pos
x
{MARKER LIST 1: 0:0;10:1;20:0;30:1}
BB:DM:CLIS:TAG? 'MARKER LIST 1'
Queries the content of the MARKER LIST 1 tag of the selected
control list file.
Response: '0:0;10:1;20:0;30:1'
The marker setting for samples 0 to 9 = 0 (low), for 10 to 19 = 1
(high) and for 20 to 29 = 0. From sample 30 onward the marker
setting = 1.
{LEVATT LIST 1: 0:0;10:1;20:0;30:1}
BB:DM:CLIS:TAG? 'LEVATT LIST 1'
Queries the content of the LEVATT LIST 1 tag of the selected
control list file.
Response: '0:0;10:1;20:0;30:1'
Level attenuation applies to data values 10 to 19 (high) and from
data value 30 onward.
Setting only
Specifies the number of bytes in a WAVEFORM tag and is calcula-
ted as follows:
Length = Number of I/Q pairs * 4 (2 bytes per I and 2
bytes per Q value) + 1 byte (the length of the #)
Waveform and List Format
exclusive in ASCII format.
x+1
Tag Description
508