R&S SGT100A User Manual page 133

®
R&S SGT100A
Carrier Table Assistant
Number of Carriers
Sets the number of carriers for the multi carrier waveform.
By default the multi carrier table lists 1 carrier. When the number of carriers is
increased, the multi carrier table is extended by adding further lines at the end of the
table. If these carrier already have been defined before, the settings are preset accord-
ing to the former settings. Otherwise the parameters are preset with the default values.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier:COUNt
Carrier Start
Defines the start index of the carrier range to which the assistant settings are intended
to apply.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STARt
Carrier Stop
Defines the stop index of the carrier range to which the assistant settings are intended
to apply.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STOP
Carrier State
Switches the carriers in the range "Carrier Start" to "Carrier Stop" on/off.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:STATe
Gain Start
Sets the gain of the carrier marked by "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer[:STARt]
on page 379
Gain Step
Sets the step width that is used to increment the gain
The resulting carrier gain in the carrier table equals:
GainStart + n* Gain Step
where n ranges from 0 to ("Carrier Stop" - "Carrier Start" ).
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer:STEP
on page 379
Phase Start
Sets the phase of the carrier marked by "Carrier Start".
User Manual 1176.8674.02 ─ 07
Signal Generator Settings
Baseband
on page 370
on page 380
on page 380
on page 380
102