Baseband Input Settings Menu; Baseband Input General Settings - R&S SGT100A User Manual

®
R&S SGT100A
7.9.2.1

Baseband Input Settings Menu

This dialog comprises the settings necessary to adjust the signal parameters, like the
sample rate, the baseband input level and to perform simple signal monitoring.

Baseband Input General Settings

► To access this dialog, select "SGMA-GUI > Instrument Name > BB Input > Digital
BB In >General".
In this section, you can activate the baseband input and get information about the
connected devices.
State
Switches On/Off the feeding of an external digital signal into the signal path.
"On"
"Off"
Remote command:
[:SOURce<hw>]:BBIN:STATe
I/Q-Swap
Activates swapping of the I and Q signal components, which mirrors the spectrum at
the f=0 line and inverts the sign of the frequency.
Remote command:
[:SOURce<hw>]:BBIN:IQSWap[:STATe]
Connected Device
Indicates the ID of a connected R&S Instrument or R&S device.
If supported by the transmitter, also the transmitter sample rate is shown.
User Manual 1176.8674.02 ─ 07
Switches On the external I/Q input signal of the "BB In" block. The
input symbol displays the active signal mode.
Switches Off the external I/Q input signal.
on page 407
Signal Generator Settings
External Baseband Signal - Baseband Input
on page 402
238