R&S SGT100A User Manual page 395

®
R&S SGT100A
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PATTern <Pattern>
The command defines the bit pattern used to generate the marker signal in the setting
SOURce:BB:ARB:TRIGger:OUTPut:MODE PATTern 0 is marker off, 1 is marker on.
Parameters:
<Pattern>
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:DIVider <Divider>
The command sets the divider for the pulsed marker signal in the setting
SOURce:BB:ARB:TRIGger:OUTPut:MODE PULSe. The pulse frequency is derived
by dividing the symbol rate by the divider.
Parameters:
<Divider>
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:FREQuency?
The command queries the pulse frequency of the pulsed marker signal in the setting
SOURce:BB:ARB:TRIGger:OUTPut:MODE PULSe. The pulse frequency is derived
by dividing the symbol rate by the divider. The divider is defined with com-
mand :BB:ARB:TRIG:OUTP:PULS:DIV.
Return values:
<Frequency>
Example:
Usage:
User Manual 1176.8674.02 ─ 07
<32 bits pattern>
*RST: 0
BB:ARB:TRIG:OUTP2:PATT #H39FE0000,32
sets a bit pattern.
BB:ARB:TRIG:OUTP2:MODE PATT
activates the marker signal according to a bit pattern on output
MARKER 2.
See "Marker Mode" on page 120
integer
Range: 2 to 1024
*RST: 2
See "Marker Mode" on page 120
float
Increment: 0.001
BB:ARB:TRIG:OUTP2:PULS:DIV 4
sets the divider for the marker signal on the output to the value
4.
BB:ARB:TRIG:OUTP2:MODE PULS
enables the pulsed marker signal.
BB:ARB:TRIG:OUTP2:PULS:FREQ?
queries the pulse frequency of the marker signal.
Response: 33 000
the resulting pulse frequency is 33 kHz.
Query only
Remote Control Commands
SOURce Subsystem
364