R&S SGT100A User Manual page 502

®
R&S SGT100A
Parameters:
<SBandwidth>
Example:
Manual operation:
[:SOURce]:ROSCillator[:INTernal]:ADJust[:STATe] <State>
Determines whether the calibrated (OFF) or a user-defined (ON) adjustment value is
used for fine adjustment of the frequency.
If user-defined values are used, the instrument is no longer in the calibrated state.
However, the calibration value is not changed and the instrument resumes the calibra-
ted state after sending the command :SOURce:ROSCillator:INTernal:ADJust:
STATe OFF.
Parameters:
<State>
Example:
Manual operation:
[:SOURce]:ROSCillator[:INTernal]:ADJust:VALue <Value>
Allows an application to shift the reference oscillator frequency by a small amount.
The setting range depends on the reference oscillator type and its factory calibration
value. Allowed are the following ranges:
●
For TCXO oscillator: Max - Min = 1023
●
For OCXO oscillator: Max - Min = 65535 (option R&S SGT-B1 required.)
User Manual 1176.8674.02 ─ 07
WIDE | NARRow
NARRow
The synchronization bandwidth is.
WIDE
Synchronization bandwidth is.
ROSC:SOUR EXT
Selects the external source.
ROSC:EXT:FREQ 10 MHz
Informs the instrument that the external reference has a fre-
quency of 10 MHz.
ROSC:EXT:SBAN WID
Selects wideband setting for synchronization bandwidth.
See "Synchronization Bandwidth"
0 | 1 | OFF | ON
*RST: -
ROSC:SOUR INT
Selects the internal source.
ROSC:ADJ ON
Activates use of a user-defined adjustment value.
ROSC:ADJ:VAL 1400
Sets the adjustment value to 1400.
See "Adjustment Active"
Remote Control Commands
SOURce Subsystem
on page 203
on page 204
471