R&S SGT100A User Manual page 134

®
R&S SGT100A
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:PHASe[:STARt]
on page 379
Phase Step
Sets the step width that is used to increment the phase.
The resulting phase in the carrier table equals:
PhaseStart + n* PhaseStep
where n ranges from 0 to (
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:POWer:STEP
on page 379
Delay Start
Sets the delay of the carrier marked by "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:DELay[:STARt]
on page 377
Delay Step
Sets the step width that is used to increment the delay.
The resulting delay in the carrier table equals:
DelayStart + n* DelayStep
where n ranges from 0 to (
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:DELay:STEP
on page 377
Input Waveform File
Calls the "File" dialog for selecting the inputfile with the I/Q signal to be modulated onto
all carriers of the selected carrier range.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:FILE
Apply Assistant Settings
Transfer the assistant settings to the carrier table.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:EXECute
on page 377
Carrier Table
The table displays the settings of all available carriers. Previously applied assistant set-
tings can be further refined. The number of lines corresponds to the number of carriers.
Note: The phase/deg settings are only valid if optimization of the crest factor is dis-
abled ("Crest Factor Mode" = Off).
User Manual 1176.8674.02 ─ 07
Carrier Stop – Carrier Start
Carrier Stop – Carrier Start
Signal Generator Settings
Baseband
)
).
on page 378
103