Noise Power/ Output Results Settings - R&S SGT100A User Manual

®
R&S SGT100A
Sets the ratio of minimum noise bandwidth to system bandwidth, as required by some
standards.
Noise Bandwidth = System BW x Minimum Noise/System BW Ratio
The parameter
The calculation of level from the selected C/N or S/N ratio in relation to system band-
width is not influenced.
Remote command:
[:SOURce<hw>]:AWGN:BWIDth:RATio
Target CW Frequency Offset
Available only for "Mode > CW Interferer".
Sets the desired frequency of the sine wave.
Remote command:
[:SOURce<hw>]:AWGN:FREQuency:TARGet
Resulting CW Frequency Offset
Available only for "Mode > CW Interferer".
Indicates the resulting frequency offset of the sine wave.
Remote command:
[:SOURce<hw>]:AWGN:FREQuency:RESult?
7.2.2.2

Noise Power/ Output Results Settings

► To access the dialog box, select "SGMA-GUI > Instrument Name > AWGN > Noise
Power/ Output Results"
User Manual 1176.8674.02 ─ 07
Additive White Gaussian Noise (AWGN) - Noise Generator
Noise Bandwidth displays the resulting noise bandwidth.
Signal Generator Settings
on page 344
on page 346
on page 345
127