[:Source<Hw>]:Bb:arbitrary:mcarrier:clipping:cfactor; [:Source<Hw>]:Bb:arbitrary:mcarrier:clipping:cutoff - R&S SGT100A User Manual

®
R&S SGT100A
Parameters:
<Mode>
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CLIPping:CFACtor <CFactor>
Sets the value of the desired crest factor, if baseband clipping is enabled
(BB:ARB:MCAR:CLIP:STAT ON).
A Target Crest Factor above the crest factor of the unclipped multicarrier signal has no
effect.
Parameters:
<CFactor>
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CLIPping:CUToff <Cutoff>
Sets the cut off frequency of the final lowpass filter, if baseband clipping is enabled
(BB:ARB:MCAR:CLIP:STAT ON).
User Manual 1176.8674.02 ─ 07
OFF | MIN | MAX
OFF
There is no automatic setting for minimizing or maximizing the
crest factor. The Phase setting (command
BB:ARB:MCAR:CARR:PHAS) is in use.
MIN
The crest factor is minimized by internally calculating optimized
carrier phases. The Phase setting (command
BB:ARB:MCAR:CARR:PHAS) is invalid.
MAX
The crest factor is maximized by internally calculating optimized
carrier phases. The Phase setting (command
BB:ARB:MCAR:CARR:PHAS) is invalid.
*RST: OFF
BB:ARB:MCAR:CFAC:MODE OFF
switches off automatic crest factor optimization. The setting
SOUR:BB:ARB:MCAR:CARR:PHAS has an effect.
See "Crest Factor Mode"
float
Range: -50 to 50
Increment: 0.01
*RST: 50
Default unit: dB
BB:ARB:MCAR:CLIP:STAT ON
enables clipping.
BB:ARB:MCAR:CLIP:CFAC 37 dB
sets the target crest factor.
See "Target Crest Factor"
Remote Control Commands
SOURce Subsystem
on page 97
on page 98
374