R&S SGT100A User Manual page 125

®
R&S SGT100A
The carriers are centered toward the RF frequency or baseband DC line, respectively.
The carrier spacing is adjustable within the total available baseband bandwidth. Each
carrier can be separately defined in terms of power, phase and modulated input signal.
Optionally, crest factor optimization can be applied.
Thus, multi-carrier waveforms can be easily configured as broadband test signals and
used for such purposes as transmitter or receiver tests. Even complex multi-carrier
scenarios composed of signals from different digital standards can be created and
used for these tests.
Example for the creation of a multi-carrier waveform file
1. Configure general settings.
2. Configure carrier table.
3. Enter filename of the multi-carrier waveform ("Output File").
4. Save and load the multi-carrier waveform ("Create" or "Create and Load").
User interface
To access the "Multi Carrier" dialog, select "Baseband > ARB > Multi Carrier...".
User Manual 1176.8674.02 ─ 07
Signal Generator Settings
Baseband
94