R&S SGT100A User Manual page 91

®
R&S SGT100A
Freq/Freq (Offs)
Sets the RF frequency, incl. enabled frequency offset.
The following apples:
"Freq" =
Where, the value set with the parameter "SGMA-GUI main panel > instrument name >
Frequency/Phase > Frequency" is the RF frequency at the RF output, without the fre-
quency offset.
The icon "Freq (Offs)" indicates that a frequency offset is applied.
Remote command:
[:SOURce]:FREQuency[:CW|FIXed]
RF On/Off
Activates and deactivates the RF output signal.
The current state of the RF output (activated and deactivated) is indicated in the main
panel by the different block color (blue or grey) and the status "On/Off".
Remote command:
:OUTPut[:STATe]
I/Q Mod State
Switches the I/Q modulation on and off.
The following functions have the same effect:
●
The "Mod On/Off" icon in the SGMA-GUI.
●
The "I/Q Mod > On/Off" in the
●
The "I/Q Modulator" >
Remote command:
[:SOURce]:IQ:STATe
Level/Level Offset
Sets the RF level at the RF output connector of the selected instrument.
If you set a digital attenuation, while "I/ Q Mod > Modulation Source > Internal Base-
band" and "I/ Q Mod > Modulation State > ON", it will be indicated in the R&S SGMA-
GUI main panel by a change in the name of this parameter from "Level" to "Level Off-
set".
Note: The SCPI command
AMPLitude]
set while
Remote command:
[:SOURce]:POWer[:LEVel][:IMMediate][:AMPLitude]
[:SOURce]:POWer:POWer
User Manual 1176.8674.02 ─ 07
Frequency + Offset
on page 328
State
on page 424
[:SOURce]:POWer[:LEVel][:IMMediate][:
sets the level of the "Level" display, that means the level containing off-
[:SOURce]:POWer:POWer
on page 468
Understanding the R&S SGMA-GUI Software
on page 340
I/Q Mod block in the block diagram.
parameter.
sets the level at the RF output connector.
Main Panel
on page 468
60