R&S SGT100A User Manual page 475

®
R&S SGT100A
Parameters:
<P>,<Vcc>
Example:
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:ENVelope:SHAPing:FILE:NEW
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:ENVelope:SHAPing:PV:FILE:NEW
Stores the shaping values into a file with the selected file name and loads it.
The file is stored in the default directory or in the directory specified with the absolute
file path. If the file does not yet exist, a new file is created. The file extension is
assigned automatically.
Setting parameters:
<Filename>
<P>,<Vcc>
Example:
Usage:
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:ENVelope:SHAPing:INTerp <Interpolation>
For envelope shaping with shaping tables, enables linear interpolation.
Parameters:
<Interpolation>
Example:
Manual operation:
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:ENVelope:SHAPing:COEFficients
Sets the polynomial coefficients.
Example:
Manual operation:
User Manual 1176.8674.02 ─ 07
Sequence of up to 4000 comma-separated value pairs.
See Example "Generating an RF envelope signal and defining
the shaping function"
<Filename>,<P>,<Vcc>
string
value pairs
See Example "Generating an RF envelope signal and defining
the shaping function"
Setting only
OFF | LINear | POWer
LINear = Linear (Voltage)
POWer = Linear (Power)
*RST:
See Example "Generating an RF envelope signal and defining
the shaping function"
See "Interpolation"
See Example "Generating an RF envelope signal and defining
the shaping function"
See "Polynomial Order"
Remote Control Commands
on page 432
on page 432
OFF
on page 432
on page 174
on page 432
on page 178
SOURce Subsystem
444