Status Subsystem - R&S SGT100A User Manual

®
R&S SGT100A
Parameters:
<Value>
Manual operation:

11.15 STATus Subsystem

This system contains the commands for the status reporting system. See also
ter 15.1.5, "Status Reporting
*RST
Value ranges
●
Queries return the current value of the respective register, which permits a check of
the device status.
Return values: A decimal value in the range 0 to 32767 (=2
●
The configuration commands set the respective register thus determining which
status changes of the R&S SGT cause the status registers to be changed.
Setting values: A decimal value in the range 0 to 32767 (=2
:STATus:OPERation:CONDition
:STATus:OPERation:ENABle
:STATus:OPERation[:EVENt]
:STATus:OPERation:NTRansition
:STATus:OPERation:PTRansition
:STATus:PRESet
:STATus:QUEStionable:CONDition
:STATus:QUEStionable:ENABle
:STATus:QUEStionable[:EVENt]
:STATus:QUEStionable:NTRansition
:STATus:QUEStionable:PTRansition
:STATus:QUEue[:NEXT]?
:STATus:OPERation:CONDition <Condition>
Sets the content of the CONDition part of the STATus:OPERation register. This part
contains information on the action currently being performed in the instrument. The
content is not deleted after being read out because it indicates the current hardware
status.
Parameters:
<Condition>
Example:
User Manual 1176.8674.02 ─ 07
integer
Range:
*RST:
See "DAC Value"
on page 307 has no effect on the status registers.
.......................................................................................... 473
.......................................................................................... 473
........................................................................................................... 474
............................................................................................... 475
string
:STATus:OPERation:CONDition?
queries the Status:Operation:Condition register.
Min to Max
32767
on page 205
System", on page 537 for detailed information.
...................................................................................... 472
....................................................................................473
.................................................................................... 473
..................................................................................474
...................................................................................... 474
......................................................................................474
................................................................................475
................................................................................475
Remote Control Commands
STATus Subsystem
Chap-
15
-1)
15
-1)
472