R&S SGT100A User Manual page 159

®
R&S SGT100A
Noise Bandwidth
Available only for "Mode > Additive Noise" and "Mode >Noise Only" and when the
AWGN generator is activated.
Indicates the real noise bandwidth.
Remote command:
[:SOURce<hw>]:AWGN:BWIDth:NOISe?
Display Mode
Sets the output to which the displayed settings are related to.
This setting also influences:
●
The way the interfering parameters are displayed, e.g. if the SNR value is defined
as C/N or as S/N.
●
The value units:
–
–
Remote command:
[:SOURce<hw>]:AWGN:DISP:MODE
Set Noise Power Via
Available only for "Mode > Additive Noise".
Selects the way the noise power is determined.
The following correlation applies:
User Manual 1176.8674.02 ─ 07
Additive White Gaussian Noise (AWGN) - Noise Generator
The values related to the RF outputs are displayed in dBm
The values related to the baseband outputs - in dB
Signal Generator Settings
on page 343
on page 344
128