Network Settings - R&S SGT100A User Manual

®
R&S SGT100A
Note: A firmware update and the required subsequent restart and the automatically ini-
tiated internal adjustment process of the controller may be a time consuming operation.
This feature accelerates the update process and the required restart of the external PC
can be executed once after the update operation of all instruments is completed.
Security Password
Enters the password that is required to enable or to disable the settings protected by a
security password. The default is '123456'.
Note: It is highly recommended to change the default security password before con-
necting the instrument to the network. To change the security password, select
"SGMA-GUI > Instrument Name > Setup > Security > Change Security Password".
The settings are only accepted after the "Accept" button is pressed.
Accept
Accept the selected operation and perform the required procedure.

8.9 Network Settings

The instrument is equipped with a network interface and can be connected to an Ether-
net LAN (local area network). The "Network Settings" dialog provides access to the
network settings.
Risk of network errors!
Connection errors can affect the entire network.
If your network does not support DHCP, or if you choose to disable dynamic TCP/IP
configuration, you must assign valid address information before connecting the instru-
ment to the LAN.
Contact your network administrator to obtain a valid IP address.
► To access this dialog, select "SGMA-GUI > Instrument Name > Setup > Network
Settings".
User Manual 1176.8674.02 ─ 07
General Instrument Settings and Instrument Setup
Network Settings
256