[:Source<Hw>]:Correction[:State]; [:Source<Hw>]:Correction:value; [:Source<Hw>]:Correction:zeroing:state - R&S SGT100A User Manual

®
R&S SGT100A
Example:
Manual operation:
[:SOURce<hw>]:CORRection[:STATe] <State>
Activates/deactivates level correction. Level correction is performed using the table
which has been selected with the command
SELect].
Parameters:
<State>
Example:
Manual operation:
[:SOURce<hw>]:CORRection:VALue?
Queries the current value for user correction.
Return values:
<Value>
Example:
Usage:
Manual operation:
[:SOURce<hw>]:CORRection:ZERoing:STATe <State>
Activates the zeroing procedure before filling the user correction data acquired by a
sensor.
Parameters:
<State>
Manual operation:
User Manual 1176.8674.02 ─ 07
CORR:CSET '/var/user/ucor1'
selects the table ucor1.
CORR ON
activates level correction. Correction is performed using the
table ucor1.
See " User Cor. Data - User Correction "
[:SOURce<hw>]:CORRection:CSET[:
0 | 1 | OFF | ON
*RST: 0
SOUR:CORR:CSET '/var/user/ucor1'
selects the table ucor1.
SOUR:CORR ON
activates user correction.
See " State " on page 213
float
Range: -100 to 100
Increment: 0.01
*RST: 0
CORR:VAL?
queries the value currently used for level correction.
Response: -3
the correction value is - 3 dB.
Query only
See " User Correction "
0 | 1 | OFF | ON
See " Fill User Correction Data with Sensor"
Remote Control Commands
SOURce Subsystem
on page 213
on page 213
on page 219
422