Table of Contents
Advertisement
L
C
OGGING
OMMANDS
LOG PERMANENT
log permanent
Overview
This command configures the device to send permanent log messages to
non-volatile storage (NVS) on the device. The content of the permanent log is
retained over a reboot. Once the permanent log reaches its configured maximum
allowable size old messages will be deleted to make way for new messages.
The no variant of this command configures the device not to send any messages
to the permanent log. Log messages will not be retained over a restart.
log permanent
Syntax
no log permanent
Mode
Global Configuration
Examples
To enable permanent logging use the following commands:
awplus#
awplus(config)#
To disable permanent logging use the following commands:
awplus#
awplus(config)#
Related
clear log permanent
Commands
default log permanent
log permanent (filter)
log permanent exclude
log permanent size
show log config
show log permanent
C613-50103-01 REV A
configure terminal
log permanent
configure terminal
no log permanent
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
359
Advertisement
Table of Contents
